Mekanisk vibration och stöt - Mätning och bedömning av maskinvibrationer - Del 8: Kolvkompressorsystem (ISO 20816-8:2018, IDT)
Status:
Gällande
Köp denna standard
StandardSvensk standard
·
SS-ISO 20816-8:2021
Mekanisk vibration och stöt - Mätning och bedömning av maskinvibrationer - Del 8: Kolvkompressorsystem (ISO 20816-8:2018, IDT)
Prenumerera på standarder med tjänst SIS Abonnemang. Genom att prenumerera får du effektiv åtkomst till gällande standarder och säkerställer att ditt företag alltid har tillgång till senaste utgåvan.
Läs mer om SIS Abonnemang
This document establishes procedures and guidelines for the measurement and classification of mechanical vibration of reciprocating compressor systems. The vibration values are defined primarily to classify the vibration of the compressor system and to avoid fatigue problems with parts in the reciprocating compressor system, i.e. foundation, compressor, dampers, piping and auxiliary equipment mounted on the compressor system. Shaft vibration is not considered.
This document applies to reciprocating compressors mounted on rigid foundations with typical rotational speed ratings in the range 120 r/min up to and including 1 800 r/min. The general evaluation criteria which are presented relate to operational measurements. The criteria are also used to ensure that machine vibration does not adversely affect the equipment directly mounted on the machine, e.g. pulsation dampers and the pipe system.
NOTE The general guidelines presented in this document can also be applied to reciprocating compressors outside the specified speed range but different evaluation criteria might be appropriate in this case.
The machinery driving the reciprocating compressor, however, is evaluated in accordance with the appropriate part of ISO 10816, ISO 20816 or other relevant standards and classification for the intended duty. Drivers are not included in this document.
It is recognized that the evaluation criteria might only have limited application when considering the effects of internal machine components, e.g. problems associated with valves, pistons and piston rings might be unlikely to be detected in the measurements. Identification of such problems can require investigative diagnostic techniques which are outside the scope of this document.
Examples of reciprocating compressor systems covered by this document are
— horizontal, vertical, V-, W- and L-type compressor systems,
Mekanisk vibration och stöt - Mätning och bedömning av maskinvibrationer - Del 8: Kolvkompressorsystem (ISO 20816-8:2018, IDT)
Prenumerera på standarder med tjänst SIS Abonnemang. Genom att prenumerera får du effektiv åtkomst till gällande standarder och säkerställer att ditt företag alltid har tillgång till senaste utgåvan.
Läs mer om SIS Abonnemang
Internationell titel: Mechanical vibration - Measurement and evaluation of machine vibration - Part 8: Reciprocating compressor systems (ISO 20816-8:2018, IDT)
Artikelnummer: STD-80031993
Utgåva: 1
Fastställd: 2021-10-28
Antal sidor: 44
Inom samma område
Varorna och tjänsterna som listas nedan ligger i samma ämnesområde (ICS-kod).