StandardSwedish standard
·
SS-EN 845-3:2013+A1:2016
Specification for ancillary components for masonry - Part 3: Bed joint reinforcement of steel meshwork
Status:
Valid
Buy this standard
StandardSwedish standard
·
SS-EN 845-3:2013+A1:2016
Specification for ancillary components for masonry - Part 3: Bed joint reinforcement of steel meshwork
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions
This European Standard specifies the requirements for masonry bed joint reinforcement for structural use (see 5.2.1) and for non-structural use (see 5.2.2). Where products are intended for use in cavity wall construction, this European Standard covers only the performance of the meshwork as reinforcement in bed joints and not its performance as wall ties across the cavity. This European Standard is not applicable to: a) products in the form of individual bars or rods; b) products formed from materials other than specified grades of austenitic stainless steel, austenitic ferritic stainless steel, zinc pre-coated steel sheet or zinc coated steel wire with or without organic coating. NOTE Annex ZA refers only to welded wire meshwork intended for structural use referred to in 5.2.1 as there are no known regulated requirements for products of this family for non-structural use.
StandardSwedish standard
·
SS-EN 845-3:2013+A1:2016
Specification for ancillary components for masonry - Part 3: Bed joint reinforcement of steel meshwork
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions